l2-service-policy
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
891
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
L2-SERVICE-POLICY
l2-service-policy {in|out} <policy-map name>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
entered in the Interface Configuration mode. This command is used to attach a
policy map to an interface either in ingress or egress direction.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if Serial0/0:0)# l2-service-policy in P1
RELEASE HISTORY
Release 3.0: command was added.
Parameter Description
in Ingress direction.
out Egress direction.
policy-map name Name of the policy map.
To Next Page
Loading...
