Alcatel-Lucent OmniAccess 5740 - Ip Dhcp Option Ntp Server

DHCP (Dynamic Host Configuration Protocol) Server
Left running head:
Chapter name (automatic)
932
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP DHCP OPTION NTP SERVER
ip dhcp option ntp-server <ip-address> [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the IP address of the Network Time Protocol server to be used by the
clients.
PARAMETERS
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# ip dhcp option ntp-server 1.1.1.1
RELEASE HISTORY
Release 2.3: Parameter [vrf <vrf-name>] was added.
Parameter Description
ip-address IP address of the Network Time Protocol
server.
vrf-name If the VRF name is specified in the
commands, it configures the DHCP
option for the specified VRF.
If the VRF is not specified, the option is
configured for the Default VRF.