Alcatel-Lucent OmniAccess 5740 - Frame Relay Lmi Type

frame relay lmi type
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
331
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
FRAME RELAY LMI TYPE
frame-relay lmi-type {ansi|q933a}
DESCRIPTION
This command is entered in Interface Configuration Mode. This command is used
to set the LMI type to either ANSI or Q933A.
PARAMETERS
DEFAULT VALUE
The default LMI type is auto-sense.
Note: LMI Autosense is activated by default as the system acts as a DTE. The LMI
autosense will be activated when the physical interface is up and LMI type is not
configured on that interface.
EXAMPLE
ALU(config-if mlfr100)# frame-relay lmi-type ansi
Parameter Description
ansi American National Standards Institute
T1.617 Annex D.
q933a ITU-T Q.933 Annex A.