802.1X Port-Based Authentication
Left running head:
Chapter name (automatic)
218
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
DOT1X PORT-CONTROL
dot1x port-control [auto|forced-authorized|forced-unauthorized]
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to enable 802.1X port-based authentication on the L2 interface.
PARAMETERS
DEFAULT VALUE
The default authentication is forced-authorized.
EXAMPLE
ALU(config-if switchport5/0)# dot1x port-control auto
DOT1X REAUTHENTICATION
dot1x reauthentication
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to enable periodic reauthentication of the client.
PARAMETERS
None.
DEFAULT VALUE
By default, this is disabled.
EXAMPLE
ALU(config)# dot1x system-auth-control
Parameter Description
auto Network access is granted only on
authorization.
forced-authorized Network access is granted without
authorization.
forced-unauthorized Port is disabled for data transfer.
To Next Page
Loading...
