Quality of Service
Left running head:
Chapter name (automatic)
896
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
POLICE
police {committed-rate <8000-10000000>} [commit-action
{drop|set {ecn-ce|fr-becn|fr-de|fr-fecn|ip-dscp {<0-63>|<dscp-
mnemonics>}|ip-precedence {<0-7>|<precedence-mnemonics>}|tos
{<0-15>|<tos-mnemonics>}|transmit}] [committed-burst {<40-
400000> exceed-action {drop|set {ecn-ce|fr-becn|fr-de|fr-
fecn|ip-dscp {<0-63>|<dscp-mnemonics>}|ip-precedence {<0-7>|
<precedence-mnemonics>}|tos {<
0-15>|<tos-mnemonics>}|transmit}]
[excess-burst {<40-400000> violate-action {drop|set {ecn-ce|fr-
becn|fr-de|fr-fecn|ip-dscp {<0-63>| <dscp-mnemonics>}|ip-
precedence {<0-7>|<precedence-mnemonics>}|tos {<0-15>|<tos-
mnemonics>}|transmit}][peak-rate <8000-10000000>]
DESCRIPTION
This command is entered in the Class Mode. This command sets the QoS traffic
policing parameters on the traffic class. This command is entered in the Class
mode. This command is used to apply policing on the traffic class. The
committed-rate keyword is compulsory. The excess-burst keyword must be
given if exceed-action parameter is set.
Action could be any one of the following: Drop, Transmit, Set (marks the packet
either in IP-precedence or IP-DSCP fields)
PARAMETERS
DEFAULT VALUE
The default value for Commit Action is Transmit. The default value for Exceed
Action is Drop. The default value for Violate Action is Drop.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-qos-P1-C1)# police committed-rate 500000 commit-
action transmit committed-burst 15625 exceed-action drop
RELEASE HISTORY
Release 2.3: Parameter {fr-becn|fr-de|fr-fecn} was added.
Parameter Description
8000-10000000 Police Committed Rate.
40-400000 Police Committed Burst.
40-400000 Police Excess Burst.
8000-10000000 Police Peak rate.
To Next Page
Loading...
Need help?
General
