Alcatel-Lucent OmniAccess 5740 - Access-List (Extended)

Protocol Independent Features
Left running head:
Chapter name (automatic)
418
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ACCESS-LIST (EXTENDED)
access-list {<100-199>|<2000-2699>} {deny|permit} {<0-255>
|gre|icmp|ip|ipinip|pim|rsvp|tcp|udp} {source-ip-address
[source-network-number]|source-ip-address/prefix-
length|any|host <source-host-ipaddress>} {destination-ip-
address [destination-network-number]|destination-ip-address/
prefix-length|any|host <destination-host-ipaddress>}[log]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure a Extended Access-list. Extended Access-list uses both source IP
address and destination IP address.
PARAMETERS
Parameter Description
<100-199>|<2000-2699> Access list number.
0-255 IP protocol number. Access list is applied only If
packet belongs to the specified protocol number.
deny Denies access for matching conditions.
permit Permits access for matching conditions.
gre|icmp|ipinip|pim|rsv
p|tcp|udp
Access list is applied only If packet belongs to the
specified protocol.
source-ip-address
[source-network-number]
Source IP address network.
source-ip-address/
prefix-length
Source IP address network.
any From any network.
host Specify single host IP address.
source-host-ipaddress Source IP address.
destination-ip-address
[destination-network-
number]
Destination IP address network.
destination ip-address/
prefix-length
Destination IP address network.
destination-host-
ipaddress
Destination IP address.
log If access list is matched, logs the message.