hdlc down-when-looped
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
273
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
HDLC DOWN-WHEN-LOOPED
hdlc down-when-looped
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to bring down the line protocol when loopback is detected on the interface.
PARAMETERS
None.
DEFAULT VALUE
By default, bringing down of line protocol when the detected loopback is disabled.
EXAMPLE
ALU(config-if Serial0/0:0)# hdlc down-when-looped
NO DEBUG HDLC
no debug hdlc {all|keepalive [output {all|log|vty}]}
This command is entered in the Super User Mode or Configuration Mode. This
command is used to disable the debug functionality.
NO ENCAPSULATION
no encapsulation {frame-relay|ppp|mlppp|mlfr}
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to configure encapsulation on the interface to HDLC. This
command is applicable only if the encapsulation is already set to Frame Relay or
PPP.
PARAMETERS
EXAMPLE
ALU(config-if Serial0/0:0)# no encapsulation frame-relay
Parameter Description
frame-relay Frame-relay encapsulation.
ppp Point to Point Protocol encapsulation.
mlppp Multilink Point to Point encapsulation.
mlfr Multilink Frame-relay encapsulation.
To Next Page
Loading...
Need help?
General
