T1E1 Line Card
Left running head:
Chapter name (automatic)
242
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
MTU
mtu <64-1500>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the MTU value on the serial interface, i.e., the maximum size of
the transmitted layer 2 payload.
PARAMETERS
DEFAULT VALUE
The default MTU is 1500 Mbps.
EXAMPLE
ALU(config-if Serial 0/0:0)# mtu 1200
NO CLOCKSOURCE
no clocksource
This command is entered in the Controller Configuration Mode. The “no” keyword
sets the clocksource to its default. The default value for clocksource is internal.
NO CHANNEL GROUP
no channel-group <0-30>
This command is entered in the Controller Configuration Mode. This command
removes the channel groups configured on the E1 controller. The default speed is
64 Kbps.
NO ENCAPSULATION
no encapsulation
This command is entered in the Interface Configuration Mode. The “no” command
restores the encapsulation to its default. The default is HDLC.
NO FRAMING
no framing
This command is entered in the Controller Configuration Mode. The “no”
command resets the framing value to its default. The default framing value is crc4
for E1.
Parameter Description
64-1500 Size of packet in bytes in the range 64 -
1500.
To Next Page
Loading...
Need help?
General
