EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Alcatel-Lucent OmniAccess 5740
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #647 background imageLoading...
Page #647 background image
Multicast Routing
Left running head:
Chapter name (automatic)
612
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP PIM RP-CANDIDATE-PRIORITY
ip pim rp-candidate-priority <0-255>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure the priority of the RP candidate.
PARAMETERS
DEFAULT VALUE
Default priority is 0.
EXAMPLE
ALU(config)# ip pim rp-candidate-priority 10
IP PIM SPARSE-MODE
ip pim sparse-mode
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to enable PIM on an interface. After enabling this
command, PIM starts sending hello packets to form neighborship.
PARAMETERS
None.
DEFAULT VALUE
By default PIM is not enabled on an interface.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim sparse-mode
Parameter Description
0-255 Indicates the priority of the RP candidate. The RP which has
the highest priority becomes the RP for a group specified by
the group list.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals