mlppp load-threshold
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
325
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
MLPPP LOAD-THRESHOLD
mlppp load-threshold {high|low} {outbound|inbound} <1-255>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the load-threshold on an MLPPP bundle.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if mlppp100)# mlppp load-threshold high outbound 100
NO ENCAPSULATION MLPPP
no encapsulation mlppp
This command is entered in the Interface Configuration Mode. This command
sets the encapsulation on a serial interface to its default, i.e., HDLC.
NO MLPPP LOAD-THRESHOLD
no mlppp load-threshold {high|low} {outbound|inbound}
This command is entered in the Interface Configuration Mode. This command
removes the load threshold on the MLPPP bundle.
Parameter Description
high High threshold value.
low Low threshold value.
outbound Outbound traffic.
inbound Inbound traffic.
1-255 Load threshold value in the range 1-255.
To Next Page
Loading...
Need help?
General
