Border Gateway Protocol
Left running head:
Chapter name (automatic)
492
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ADDRESS-FAMILY IPV4 UNICAST
address-family ipv4 unicast
DESCRIPTION
This command is entered in the Router Configuration Mode. This command
specifies the type of address family to be created and changes the command
mode to Address Family mode.
PARAMETERS
None.
Note: In the OmniAccess 5740 USG, currently only IPv4 address family and unicast services
are supported. By default all commands are applied to ipv4 unicast address family.
EXAMPLE
ALU(config-router bgp AS30)# address-family ipv4 unicast
ALU(config-router-af-ucast)#
To Next Page
Loading...
