Alcatel-Lucent OmniAccess 5740 - Dot1 X Timeout Supp-Timeout; Dot1 X Timeout Tx-Period

dot1x timeout supp-timeout
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
221
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
DOT1X TIMEOUT SUPP-TIMEOUT
dot1x timeout supp-timeout <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the switch-to-client retransmission time for the EAP-request frame.
PARAMETERS
DEFAULT VALUE
The default is 30 seconds.
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout supp-timeout 40
DOT1X TIMEOUT TX-PERIOD
dot1x timeout tx-period <1-3600>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the number of seconds that the OmniAccess 5740 USG waits for a response
to an EAP-request/identity frame from the client before retransmitting the request.
PARAMETERS
DEFAULT VALUE
The default is 30 seconds.
EXAMPLE
ALU(config-if switchport5/0)# dot1x timeout tx-period 60
Parameter Description
1-65535
Indicates the switch-to-client
retransmission time for the EAP-request
frame.
Parameter Description
1-3600
Indicates the number of seconds that the
OmniAccess 5740 USG waits for a
response to an EAP-request/identity
frame from the client.