crc
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
263
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CRC
crc {16|32}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to enable CRC.
PARAMETERS
DEFAULT VALUE
The default CRC value is 16.
EXAMPLE
ALU(config-if Serial0/0)# crc 16
INTERFACE SERIAL
interface Serial <slot/port>
DESCRIPTION
This command is entered in the Configuration Mode to configure a serial interface
in a specific slot/port of the V.35/X.21/RS-232 card. This command enters Serial
Interface Configuration Mode.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)#interface Serial0/0
ALU(config-if Serial0/0)#
Parameter Description
16|32 These are the values you can set for the
crc.
Parameter Description
slot/port Slot and port numbers of the interface.
To Next Page
Loading...
