no ppp timeout restart-interval
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
293
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NO PPP TIMEOUT RESTART-INTERVAL
no ppp timeout restart-interval
This command is entered in the Interface Configuration Mode. The “no” command
sets the LCP/NCP restart-interval to its default, i.e., 30 seconds.
NO PPP TIMEOUT RESTART-TIMER
no ppp timeout restart-timer
This command is entered in the Interface Configuration Mode. The “no” command
resets the restart-timer to its default, i.e., 3 seconds.
PPP AUTHENTICATION
ppp authentication {pap|chap|eap}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
enables you to configure an authentication protocol for authenticating the peer.
PARAMETERS
EXAMPLE
ALU(config-if Serial0/0:0)# ppp authentication pap
Parameter Description
pap Password Authentication Protocol.
chap Challenge Authentication Protocol.
eap Extensible Authentication Protocol.
To Next Page
Loading...
Need help?
General
