Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Network Address Translation
Left running head:
Chapter name (automatic)
684
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP NAT STATISTICS {IN|OUT|BOTH}
ip nat statistics {in|out|both}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
turns on statistics for a given interface.
PARAMETERS
DEFAULT VALUE
By default the NAT statistics on an interface is turned off.
EXAMPLE
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# ip nat statistics in
NO DEBUG FIREWALL NAT
no debug firewall {session|filter|nat|attack|alg|intrusion|
selector [saddr <ip-address>|daddr <ip-address>|protocol
<number>|sport <number>|dport <number>][output|permanent]| all
[detail-level]}
This command is entered in the Super User Mode or Configuration Mode. This
command turns off the debugging functionality which is enabled using the above
command.
NO IP NAT-FORCE
no ip nat <policy-name> force
This command is entered in the Configuration Mode. The "force" keyword will
automatically detach the specified NAT policy from respective interfaces, and
deletes the policy. This command when used also deletes all the associated NAT
policy rules.
Parameter Description
in "in" means ingress traffic.
out "out" denotes that egress traffic.
both Implies both ingress and egress traffic

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English