vrrp group-id IP ip-address secondary
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
163
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
VRRP GROUP-ID IP IP-ADDRESS SECONDARY
vrrp <1-8> ip <ip-address> secondary
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the secondary IP address for a VRRP group on an interface.
Note: The maximum number of secondary IP addresses allowed per VRRP group is 8.
PARAMETERS
EXAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 ip 10.91.0.101
secondary
VRRP GROUP-ID PREEMPT
vrrp <1-8> preempt
DESCRIPTION
This command is used in the Interface Configuration Mode. This command
enables the preempt mode. By enabling the preempt mode, the configured router
takes over as the master of a group if it has a higher priority than the existing
master virtual router.
PARAMETERS
DEFAULT VALUE
Pre-emption is enabled by default.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 preempt
Parameter Description
1-8 Specifies the group number. It is in the range 1 - 8.
ip-address The secondary IP address of the VRRP group.
secondary Use this keyword to set the IP address as the
secondary IP address for the VRRP group.
Parameter Description
1-8 Specifies the group number. It is in the range 1 - 8.
To Next Page
Loading...
Need help?
General
