no crypto ipsec transform-set
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
781
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NO CRYPTO IPSEC TRANSFORM-SET
no crypto ipsec transform-set <name>
This command is entered in the Configuration Mode. This command deletes a
transform-set.
Note: If a transform-set is being used by any crypto map, it is prohibited from deletion.
Hence, the transform-set must be first disabled from the crypto map and then delete.
PEER
peer {<ip-address>|<FQDN>}
DESCRIPTION
This command is entered in the Crypto Map Configuration Mode. This command
attaches a peer to a crypto map. You can attach a maximum of four peers to a
crypto map.
PARAMETER
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-crypto-map-exampleMap)# peer 100.10.61.20
ALU(config-crypto-map-exampleMap)# peer mysmb.dyndns.org
RELEASE HISTORY
Release 3.0: Parameter “FQDN” was introduced.
parameter Description
ip-address IP address of the peer.
FQDN Fully qualified domain name (FQDN) of
the peer at the remote end.
To Next Page
Loading...
