Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Open Shortest Path First
Left running head:
Chapter name (automatic)
566
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP OSPF MTU-IGNORE
ip ospf mtu-ignore
DESCRIPTION
This command is entered in the Interface Configuration Mode. Disables detection
of OSPF MTU mismatch in Database Description Packets.
PARAMETERS
None.
DEFAULT VALUE
By default, OSPF MTU mismatch detection is enabled.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf mtu-ignore
IP OSPF NETWORK
ip ospf network {broadcast|non-broadcast| point-to-
multipoint|point-to-point}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
configures the OSPF network type for a specified interface.
PARAMETERS
DEFAULT VALUE
Depends on the interface type.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf network non-
broadcast
Parameter Description
broadcast Specifies the OSPF broadcast multi-access network.
non-broadcast Specifies the OSPF NBMA network.
point-to-
multipoint
Specifies the OSPF point-to-multipoint network.
point-to-point Specifies the OSPF point-to-point network.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English