L3 Interface Commands
Left running head:
Chapter name (automatic)
174
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ENCAPSULATION DOT1Q
encapsulation dot1q <2-4094>
DESCRIPTION
This command is entered in the Sub-interface Configuration Mode. This command
is to set dot1q encapsulation on a GigE sub-interface.
Note: 1. Bridging is not allowed on GigE sub-interface. It can be configured to receive
tagged packets by setting the encapsulation to “dot1q”.
2. The VLAN ID configured on the sub-interface should not be same as configured on
the main interface or any other sub-interface.
3. Only one VLAN ID per sub-interface is allowed.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-subif GigabitEthernet3/0:1)# encapsulation dot1q 10
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
2-4094 VLAN ID.
To Next Page
Loading...
