L3 Interface Commands
Left running head:
Chapter name (automatic)
178
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO SPEED
no speed
This command is entered in the Interface Configuration Mode. This command
resets the interface speed to its default value, which is 1000.
SHOW
show
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
displays traffic on the GigE interface.
This command when used in the Sub-interface Configuration Mode displays traffic
on the GigE sub-interface.
PARAMETERS
None.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# show
GigabitEthernet3/0 is up, line protocol is up
Hardware is Intel 82546, address is 0011.8b00.2728 (0011.8b00.2728)
Internet address is 9.9.9.9/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 0 usec,
reliability 0/255, txload 0/255, rxload 0/255
Loopback not set
Encapsulation ARPA, keepalive not set
Auto-duplex, 1000Mb/s, 1000BaseTx/Fx
ARP type: ARPA, ARP Timeout never
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue 0/0 (size/max), 0 drops; Input queue 0/0 (size/max), 0 drops
5 minute input rate 344 bits/sec, 1 packets/sec
5 minute output rate 8 bits/sec, 0 packets/sec
68 packets input, 5108 bytes, 0 no buffer
Received 39 broadcasts, 0 runts, 0 giants
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
3 packets output, 192 bytes, 0 underruns
0 output errors, 0 collisions, 0 interface resets
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer copied, 0 interrupts, 0 failures
To Next Page
Loading...
Need help?
General
