EasyManuals Logo

Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Alcatel-Lucent OmniAccess 5740
1043 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #301 background imageLoading...
Page #301 background image
Universal Serial Port (USP) Line Card
Left running head:
Chapter name (automatic)
266
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
MTU
mtu <64-1500>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the MTU value on the serial interface, i.e., the maximum size of
the transmitted layer 2 payload.
PARAMETERS
DEFAULT VALUE
The default MTU is 1500 Mbps.
EXAMPLE
ALU(config-if Serial0/0)# mtu 1200
NO CLOCKRATE
no clockrate {64000|128000|256000|512000|1024000|2048000}
This command is entered in the Interface Configuration Mode. The “no” command
sets the clock rate to default 64000 bps.
NO CRC
no crc {16|32}
This command is entered in the Interface Configuration Mode. The “no” keyword
sets the CRC value to default 16.
NO INVERT-TXC
no invert-txc
This command is entered in the Interface Configuration Mode. The “no” command
will set the clock to the original phase.
NO LOOPBACK
no loopback
This command is entered in the Interface Configuration Mode. The “no” command
removes the loopback configured on the interface.
Parameter Description
64-1500 Size of packet in bytes in the range 64 -
1500.

Table of Contents

Other manuals for Alcatel-Lucent OmniAccess 5740

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Alcatel-Lucent OmniAccess 5740 and is the answer not in the manual?

Alcatel-Lucent OmniAccess 5740 Specifications

General IconGeneral
BrandAlcatel-Lucent
ModelOmniAccess 5740
CategoryGateway
LanguageEnglish

Related product manuals