source-nat host
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
673
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SOURCE-NAT HOST
[<1-65535>] match [{all|any}] <match-list name> source-nat host
{<ip-address|host-name>} [port-range {<2048-65535> <2048-
65535>}|static]
DESCRIPTION
This command is entered in the NAT Configuration Mode. This command is used
to configure a SNAT with host IP address.
Note: If no address is configured, the IP address of the egress interface on which the NAT
policy is applied will be used.
PARAMETERS
Note: Currently, ‘Hostname’ option is not supported. Only host IP address can be
configured.
DEFAULT VALUE
If no address is configured, the IP address of the egress interface on which the
NAT policy is applied will be used.
EXAMPLE
ALU(config-nat-N1)# match m1 source-nat host 192.168.10.91
Parameter Description
1-65535 The range for the NAT policy rule. This rule number
signifies the priority of a rule.
match [{all|any}]
<match-list name>
match all - In this type of match, the relevant action is
performed only when all the match-list criteria is satisfied.
match any - In this type of match, the relevant action is
performed even if any one of the match-list criterion is
satisfied.
source-nat Type of NAT, here it is the SNAT.
ip-address IP address of the host.
host-name The host name.
To Next Page
Loading...
