Alcatel-Lucent OmniAccess 5740 Cli Command Reference Guide

Multicast Routing
Left running head:
Chapter name (automatic)
614
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP PIM QUERY-INTERVAL
ip pim query-interval <0-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. PIM router sends
periodic hello messages on all PIM enabled interfaces. Use this command to
configure this interval (in seconds).
PARAMETERS
DEFAULT VALUE
The default query-interval is 30 seconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)#ip pim query-interval 50
NO IP PIM SPARSE-MODE
no ip pim sparse-mode
This command is entered in the Interface Configuration Mode. This command is
used to disable PIM on an interface.
Parameter Description
0-65535 Denotes the interval between periodic hello messages.

Alcatel-Lucent OmniAccess 5740 Specifications

General

Brand	Alcatel-Lucent
Model	OmniAccess 5740
Category	Gateway
Language	English