Alcatel-Lucent OmniAccess 5740 - Reboot Device

T1 CLI Commands
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
247
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
T1 CLI COMMANDS
The following section gives a succinct overview on the commands that are used
only on the T1 controller.
CABLELENGTH LONG
cablelength long {-15db|-22.5db|-7.5db|0db}
DESCRIPTION
This command is entered in the Controller Configuration Mode. This command is
used to configure transmit and receive levels for a cable length (line build-out)
longer than 660 ft for a T1 trunk.
PARAMETERS
DEFAULT VALUE
Cablelength of long 0 db is the default for the T1 cards.
EXAMPLE
The following example changes transmit attenuation of controller T1 of slot 0 and
port 0 to appropriate level for long cables:
ALU(config-controller)# cablelength long -22.5db
Parameter Description
-15db Sets the receive sensitivity to -15db if the hardware
has configurable receive sensitivity.
-22.5db Sets the receive sensitivity to -22.5db if the hardware
has configurable receive sensitivity.
-7.5db Sets the receive sensitivity to -7.5 dB if the hardware
has configurable receive sensitivity.
0db Sets the receive sensitivity to 0 dB if the hardware
has configurable receive sensitivity.