Alcatel-Lucent OmniAccess 5740 - Timers Spf

timers spf
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
603
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
TIMERS SPF
timers spf {<0-65535> <0-65535>}
DESCRIPTION
This command is entered in the Router Configuration Mode. This command is
used to configure the delay time and hold time for Shortest Path First (SPF)
calculation.
PARAMETERS
DEFAULT VALUE
SPF schedule delay is 5 seconds.
Hold time between two SPFs is 10 seconds.
EXAMPLE
ALU(config-router ospf 30)# timers spf 20 10
Parameter Description
0-65535 spf delay: Delay time (in seconds)
between when OSPF receives a
topology change and when it starts an
SPF calculation. The default time is 5
seconds.
A value of ‘0; means that there is no
delay; that is, the SPF calculation starts
immediately.
0-65535 spf hold: Minimum time (in seconds)
between two consecutive SPF
calculations. The default time is 10
seconds.
A value of ‘0’ means two consecutive
SPF calculations can be done one
immediately after the other.