Alcatel-Lucent OmniAccess 5740 - Ip Access-List Extended

Protocol Independent Features
Left running head:
Chapter name (automatic)
426
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP ACCESS-LIST EXTENDED
ip access-list extended {<100-199>|<2000-2699>|<access-list-
name>}
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
define a named access list, and enters Extended Access-list Configuration mode.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config)# ip access-list extended test
ALU(config-ext-nacl)#
Configure Extended IP Access-list Rule
This command is used to configure a rule for a Extended IP Access-List. You can
configure multiple rules for an IP access list.
{permit|deny} {igre|icmp|ip|ipinip|pim| rsvp|tcp|udp|<0-
255>} {any|host <host-ip-address>|<source-ip-address/prefix-
length>|<source-ip-address subnet-mask>} [operators]
{any|host <host-ip-address>|<destination-ip-address/prefix-
length>|<destination-ip-address subnet-mask>} [log] [log-
input] [enable fragment] [precedence [<0-7>|<keywords>] [tos
[<0-15>|<keywords>]]]
Parameter Description
<100-199>|<2000-
2699>
IP access list number.
access-list-name Name of the access list.
Parameter Description
permit Result is permit if conditions are matched.
{igre|icmp|ip|ip
inip|pim|
rsvp|tcp|udp|<0-
255>}
Name or number of an Internet protocol. If a protocol is not
specified, the access-list entry applies to all protocols.
deny Result is deny if conditions are matched.