T1E1 Line Card
Left running head:
Chapter name (automatic)
244
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
SHOW CONTROLLER
show controller [{E1|T1} <slot/port>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays controller status that is specific to the controller hardware. The
show controller E1 command displays the status of the E1 controllers and
displays information about clocksources and other settings for the ports.
EXAMPLE
ALU# show controller
E1 1/0 is administratively down.
E1 1/1 is administratively down.
E1 1/2 is up.
Line Card type is Channelized E1
Line termination is 120ohm
No Alarm Detected
Framing is crc4, Line Code is hdb3, Clock Source is internal
Total Data (Since last clearing of counters)
1 Line Code Violation, 0 Framing Errors
0 CRC Errors, 0 Far End Block Errors
E1 1/3 is administratively down.
ALU# show controller E1 1/2
E1 1/2 is up.
Line Card type is Channelized E1
Line termination is 120ohm
No Alarm Detected
Framing is crc4, Line Code is hdb3, Clock Source is internal
Total Data (Since last clearing of counters)
1 Line Code Violation, 0 Framing Errors
0 CRC Errors, 0 Far End Block Errors