no linecode
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
243
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NO LINECODE
no linecode
This command is entered in the Controller Configuration Mode. The “no”
command sets the linecode to its default value.The default linecode value is
HDB3.
NO LINE-TERMINATION
no line-termination
This command is entered in the Controller Configuration Mode. The “no”
command sets the impedance value to its default. The default line-termination
value is 120.
NO LOOPBACK
no loopback
This command is entered in the Controller Configuration Mode. This command
disables the loopback on the interface.
NO MTU
no mtu
This command is entered in the Interface Configuration Mode. This command
sets the MTU to its default.
NO SHUTDOWN
no shutdown
This command when entered in the Controller Configuration Mode brings up the
controller.
This command when entered in the Interface Configuration Mode brings up the
interface.
To Next Page
Loading...
Need help?
General
