Alcatel-Lucent OmniAccess 5740 - No Hdlc Down-When-Looped; No Hdlc Keepalive; Show Interface

High-level Data Link Control
Left running head:
Chapter name (automatic)
274
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
NO HDLC DOWN-WHEN-LOOPED
no hdlc down-when-looped
This command is entered in the Interface Configuration Mode. This command
disables bringing down of the line protocol when loopback is detected on the
interface. This is the default behavior.
NO HDLC KEEPALIVE
no hdlc keepalive
This command is entered in the Interface Configuration Mode. This command
resets the keepalive interval to its default, which is 10 seconds.
SHOW INTERFACE
show interfaces Serial [<slot/port:channel>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. Use
this command to verify the encapsulation type and the interface details.
PARAMETERS
EXAMPLE
ALU# show interfaces Serial 0/0:0
Serial0/0:0 is up, line protocol is up
Internet address is 7.7.7.1/24
MTU 1500 bytes, BW 1536 Kbit, DLY 0 usec,
reliability 255/255, txload 0/255, rxload 2/255
Loopback not set
Encapsulation hdlc, keepalive set (10 sec)
Last input never, output never, output hang never
Last clearing of "show interface" counters never
Queueing strategy: fifo
Output queue: 0/0 (size/max) 0 drops; Input queue: 0/0 (size/max) 0
drops
Conversations: 0/0/0/0 (active/max active/max total)
Reserved Conversations: 0/0 (allocated/max allocated)
Available Bandwidth 1536 kilobits/sec
5 minute input rate 16 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
370 packets input, 8880 bytes, 0 no buffer
Received 0 broadcasts, 0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
Parameter Description
serial Type of interface.
<slot/port:channel> Interface number with slot/port and
channel group number.