Point to Point Protocol
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
287
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CHAPTER 15 POINT TO POINT PROTOCOL
This chapter documents the Command Line Interface (CLI) commands for the
Point-to-Point Protocol (PPP). These commands are used to configure PPP
encapsulation on a T1 or E1 interface or a Serial (V.35/X.21) interface.
This chapter includes table of parameters, default values, and configuration
examples for PPP configurations as quick-start and reference information. In this
chapter, all the commands are described in alphabetical order. For more detailed
information about using and configuring the Point-to-Point Protocol, refer to the
OmniAccess 5740 Unified Services Gateway CLI Configuration Guide.
To Next Page
Loading...
