Alcatel-Lucent OmniAccess 5740 - Clear Transparent-Forward Statistics; Transparent-Forward

Transparent Firewall
Left running head:
Chapter name (automatic)
876
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
CLEAR TRANSPARENT-FORWARD STATISTICS
clear transparent-forward statistics [<tf-policy name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command clears the statistics of all the TF policies configured in the system.
PARAMETERS
EXAMPLE
ALU(config)# clear transparent-forward statistics
TRANSPARENT-FORWARD
transparent-forward [<tf-policy-name>] interface <interface-
name>
DESCRIPTION
This command is entered in the Interface Configuration Mode.
This command is used to configure the TF feature on an interface (incoming
interface). You can optionally apply a TF policy (that defines the treatment of non-
IP and non-ARP packets) on the interface.
Note: ‘IP Policy’ command, if in effect, shall be cleaned up before this command takes
effect.
PARAMETERS
EXAMPLE
The following configures TF feature and binds the TF policy ‘TF1’ on the interface
GigabitEthernet3/0 with outgoing interface as VLAN 10.
ALU(config)# interface GigabitEthernet3/0
ALU(config-if GigabitEthernet3/0)# transparent-forward TF1
interface Vlan 10
Parameter Description
tf-policy name Clears the statistics for the specified TF policy.
Parameter Description
tf-policy-name Name of the TF policy to be applied on the interface.
interface-name Use this keyword to configure the outgoing interface.