Alcatel-Lucent OmniAccess 5740 - Ip Ospf Retransmit-Interval; Ip Ospf Transmit-Delay

Open Shortest Path First
Left running head:
Chapter name (automatic)
568
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
IP OSPF RETRANSMIT-INTERVAL
ip ospf retransmit-interval <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
specifies the time (in seconds) between LSA retransmissions for adjacencies
belonging to an OSPF interface.
PARAMETERS
DEFAULT VALUE
The default retransmit-interval is 5 seconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)#ip ospf retransmit-interval 6
IP OSPF TRANSMIT-DELAY
ip ospf transmit-delay <1-65535>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the estimated time in seconds required to send a link-state update packet on
an OSPF interface.
PARAMETERS
DEFAULT VALUE
The default transmit-delay is 1 second.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip ospf transmit-delay 2
Parameter Description
1-65535 Time (in seconds) between retransmissions. It must be
greater than the expected round-trip delay between any two
routers on the attached network.
Parameter Description
1-65535 Time (in seconds) required to send a link-state update. The
default is 1 seconds.