Alcatel-Lucent OmniAccess 5740 - Spanning-Tree Vlan Enable

spanning-tree vlan enable
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
205
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SPANNING-TREE VLAN ENABLE
spanning-tree enable [vlan <1-4094>]
DESCRIPTION
This command is entered in the Configuration Mode. This command enables a
spanning-tree for VLAN.
PARAMETERS
DEFAULT VALUE
By default, spanning tree is disabled.
EXAMPLE
The following command enables the spanning tree for the default VLAN-ID, i.e.,
VLAN-1.
ALU(config)# spanning-tree enable
Note: In the above example, the VLAN-ID takes a default value of 1.
The following example configures spanning tree for vlan 100.
ALU(config)# spanning-tree enable vlan 100
Command (in CM) Description
1-4094
Vlan ID configured.