Alcatel-Lucent OmniAccess 5740 - Fault-Alarm Lowest-Priority-Defect

fault-alarm lowest-priority-defect
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
353
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
FAULT-ALARM LOWEST-PRIORITY-DEFECT
fault-alarm lowest-priority-defect <1-6>
DESCRIPTION
This is entered in the OAM Domain Association MEP Configuration Mode. This
command is used to configure the lowest priority fault alarm for a MEP.
PARAMETERS
DEFAULT VALUE
The default lowest priority defect value is 2.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-oam-domain-assoc-mep)# fault-alarm lowest-priority-
defect 1
RELEASE HISTORY
Release 3.0: command was introduced.
Parameter Description
1-6 Specify the priority value for the fault
alarm.