Alcatel-Lucent OmniAccess 5740 - Bgp Log-Neighbor-Changes; Bgp Router-ID

Border Gateway Protocol
Left running head:
Chapter name (automatic)
502
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
BGP LOG-NEIGHBOR-CHANGES
bgp log-neighbor-changes
DESCRIPTION
This command is entered in the Address Family or Router Configuration Mode.
This command enables logging of messages when a BGP neighbor goes up or
down or resets.
PARAMETERS
None.
DEFAULT VALUE
Logging is disabled.
EXAMPLE
ALU(config-router AS30)# bgp log-neighbor-changes
BGP ROUTER-ID
bgp router-id <ip-address>
DESCRIPTION
This command is entered in the Address Family or Router Configuration Mode.
This command overrides the configured router identifier.
PARAMETERS
DEFAULT VALUE
Calculates Router ID from interface IP addresses.
EXAMPLE
ALU(config-router bgp AS30)# bgp router-id 1.1.1.1
Parameter Description
ip-address Router ID in the IP address format.