Alcatel-Lucent OmniAccess 5740 - Ip Igmp Query-Max-Response-Time; Ip Igmp Querier-Timeout

ip igmp query-max-response-time
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
623
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
IP IGMP QUERY-MAX-RESPONSE-TIME
ip igmp query-max-response-time <1-25>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
configures the maximum response time (in seconds) advertised in IGMP queries.
PARAMETERS
DEFAULT VALUE
The default query-max-response-time is 10 seconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp query-max-response-
time 20
IP IGMP QUERIER-TIMEOUT
ip igmp querier-timeout <60-300>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
configures the time-out value (in seconds) after which the router assumes itself to
be the querier on the interface.
Note: Make sure that all IGMP routers on LAN have same querier time-out. Else, router with
less querier time-out will always become querier.
PARAMETERS
DEFAULT VALUE
Default IGMP querier-timeout is 255 seconds.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip igmp querier-timeout 100
Parameter Description
1-25 The maximum response time advertised in IGMP queries.
Parameter Description
60-300 Querier time-out value.