OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Left running head:
Chapter name (automatic)
2
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
ORGANIZATION
The chapters in the CLI Command Reference Guide are organized into following
parts:
PART I - INTRODUCTION
The first part provides an introduction to CLI, “Using the Command Line
Interface” in Chapter 2. This is a preparatory chapter that describes the CLI
configuration considerations, tools required, an overview of the Command Line
Interface and procedures that should be performed before the actual
configuration.
Chapter 3 “System Configuration and Monitoring” chapter includes
commands for Inband and Out-of-band management, setting system parameters,
software management, configuration management, AAA services, SNMP, etc.
The various commands include SSH, Telnet, show version, update, show
environment, show mem, show proc, etc.
Chapter 4 “Virtual Router Redundancy Protocol” chapter documents the
commands for Virtual Router Redundancy Protocol (VRRP). These commands
are used to configure VRRP on an interface.
PART II - LAN INTERFACES
Chapter 5 “L3 Interface Commands”documents the CLI commands for the
Ethernet interfaces.
Chapter 6 “Switching on L2 Ports” deals with the L2 switching Configuration on
the OmniAccess 5740 USG. This chapter documents the commands for Layer 2
switching. These commands are used to configure switching on the L2 protocols.
Chapter 7 “Per VLAN Spanning Tree +” details the VLAN commands in
switching.
Chapter 8 “Integrated Routing and Bridging” covers the commands used to
configure Integrated Routing and Bridging (IRB) on the OmniAccess 5740 USG.
Chapter 9 “802.1X Port-Based Authentication” documents the commands for
IEEE 802.1X port-based authentication on the OmniAccess 5740 USG.
Chapter 10 “Port Monitoring” chapter covers the commands used to configure
Port Monitoring on the OmniAccess 5740 USG.
To Next Page
Loading...
