Alcatel-Lucent OmniAccess 5740 - Load Config-File; Logging Buffered

load config-file
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
67
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
LOAD CONFIG-FILE
load config-file <file-name>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
load a configuration file to the running configuration. This effectively leads to the
execution of all the commands in the given file. This file should be present in the
alu-config directory. (Use the copy commands to copy the file to the alu-config
directory.)
PARAMETERS
EXAMPLE
ALU# load config-file config1
Loading config1 to running-config...
/-------- Percent Complete --------
|*********************************
LOGGING BUFFERED
logging buffered [priority {<0-7>|alerts |critical|debugging
|emergencies|errors|informational|notifications|warnings}|size
<4-1024>]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
store the log information in the memory buffer. If a priority value is given,
messages of that priority and higher (numerically lower) will be buffered.
PARAMETERS
DEFAULT VALUE
By default, logging is sent to the buffer.
EXAMPLE
ALU(config)# logging buffered priority 5
Parameter Description
filename Name of the file in the alu-config
directory from where the configuration is
to be loaded.
Parameter Description
0-7 Priority level.
4-1024 Logging buffer size.