Virtual Router Redundancy Protocol
Left running head:
Chapter name (automatic)
164
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
VRRP GROUP-ID PRIORITY VALUE
vrrp <1-8> priority <1-254>
DESCRIPTION
This command is used in the Interface Configuration Mode. This command is
used to set the priority for the router within a group.
PARAMETERS
DEFAULT VALUE
By default, priority is 100
EXAMPLE
ALU(config-if GigabitEthernet3/0)# vrrp 7 priority 104
Parameter Description
1-8 Specifies the group number. It is in the range 1 - 8.
value Refers to the priority level which ranges between
1- 254.
To Next Page
Loading...
Need help?
General
