Customized-service Rule Based ALG Configuration Commands
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
751
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
CUSTOMIZED-SERVICE RULE BASED ALG CONFIGURATION
C
OMMANDS
CHANGE
change {<1-65535> <1-65535>}
DESCRIPTION
This command is entered in the Customized Service Mode. Use this command to
change the priority of a specific ALG rule configured.
PARAMETERS
EXAMPLE
The following example shows how to change the priority of an ALG rule;
ALU(config-customized-service)# change 10 1
CUSTOMIZED-SERVICE
customized-service
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure ALG. This also enters into customized service configuration mode.
PARAMETERS
None.
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)#customized-service
Parameter Description
1-65535 Denotes the ALG rule number. This rule
number signifies the priority of a rule.
To Next Page
Loading...
Need help?
General
