Alcatel-Lucent OmniAccess 5740 - Encapsulation Frame-Relay; Frame Relay Interface-Dlci

encapsulation frame-relay
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
279
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
ENCAPSULATION FRAME-RELAY
encapsulation frame-relay
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to set encapsulation on an interface to Frame Relay.
PARAMETERS
None.
DEFAULT VALUE
HDLC is the default encapsulation on an interface.
EXAMPLE
ALU(config-if serial 0/0:0)# encapsulation frame-relay
FRAME RELAY INTERFACE-DLCI
frame-relay interface-dlci <16-1007>
DESCRIPTION
This command is entered in the Interface Configuration Mode or Sub-Interface
Configuration Mode. This command is used to configure a DLCI on an interface/
sub-interface.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
The following example sets the DLCI value to 100:
ALU(config-if Serial 0/0:0)# frame-relay interface-dlci 100
Parameter Description
16-1007 The DLCI value.