Alcatel-Lucent OmniAccess 5740 - Access-List (Standard)

access-list (standard)
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
419
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
DEFAULT VALUE
By default, no access list is configured.
EXAMPLE
ALU(config)# access-list 101 permit ip 162.168.0.0
255.255.0.0 170.170.0.0 255.255.0.0
ACCESS-LIST (STANDARD)
access-list {<1-99>|<1300-1999>} {deny|permit} {source-ip-
address <network-number>|ip-address/prefix-length|any|host
<host-ipaddress>}[log]
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
configure a Standard Access-list. Standard Access-list uses only source IP
address.
PARAMETERS
DEFAULT VALUE
By default, no access list is configured.
EXAMPLE
ALU(config)# access-list 1 deny 1.0.0.0/8
ALU(config)# access-list 2 permit 20.0.0.0/8
Parameter Description
{<1-99>|<1300-
1999>}
Access list number.
deny Denies access for matching conditions.
permit Permits access for matching conditions.
source-ip-
address
<network-number>
Source IP address network.
ip-address/
prefix-length
Source IP address network.
any Match all source network.
host-ipaddress Match only specified IP address.
log If access list is matched, logs the message.