Alcatel-Lucent OmniAccess 5740 - Match Metric; Maximum-Paths

Protocol Independent Features
Left running head:
Chapter name (automatic)
440
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
MATCH METRIC
match metric <0-4294967295>
DESCRIPTION
This command is entered in the Route-Map Configuration Mode. This command
matches the specified metric.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-route-map)# match metric 10
MAXIMUM-PATHS
maximum-paths <number of paths>
DESCRIPTION
This command is entered in the Router Configuration Mode. This command is
used to configure the maximum number of parallel paths to be allowed in a routing
table.
PARAMETERS
DEFAULT VALUE
By default, OSPF, BGP and Static routes can install a maximum number of 16
ECMP paths. And, RIP installs maximum 8 ECMP paths.
EXAMPLE
ALU(config-router ospf 1)# maximum-paths 5
Parameter Description
0-4294967295 Route map result is permit if route metric matches the
specified metric.
Parameter Description
number-of-paths Maximum number of parallel routes an IP routing protocol
installs in a routing table, in the range from 1 to 6.