Alcatel-Lucent OmniAccess 5740 - Show Arp Traffic

show arp traffic
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
653
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
SHOW ARP TRAFFIC
show arp traffic [vrf <vrf-name>]
DESCRIPTION
This command is entered in the Super User Mode or Configuration Mode. This
command displays the ARP traffic statistics.
PARAMETERS
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config)# show arp traffic vrf ALU-vrf
ARP Traffic statistics:
Request Recvd :0 Request Sent :6
Response Recvd :1 Response Sent :0
Rate limiting:
Request Not Answered :0
Request Not Sent: 0
ADJ count exceeded :0
Errors:
Req/Resp recvd without Mac on interface :0
Req not sent because of no IP Address :0
Req not sent becuase of no MAC :0
Resp received without req :0
RELEASE HISTORY
Release 2.3: command was introduced.
Parameter Description
vrf-name If the VRF name is specified, it displays the
ARP traffic statistics for the specified VRF, else
it displays the statistics for the default VRF.