Alcatel-Lucent OmniAccess 5740 - Ip Pim Dr-Priority; Ip Pim Message-Interval

ip pim dr-priority
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
609
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
IP PIM DR-PRIORITY
ip pim dr-priority <0-4294967294>
DESCRIPTION
This command is entered in the Interface Configuration Mode. Specifies PIM
router DR priority on interface. This DR priority is used in the DR election
algorithm.
PARAMETERS
DEFAULT VALUE
Default DR-priority is 1.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# ip pim dr-priority 2
IP PIM MESSAGE-INTERVAL
ip pim message-interval <1-65535>
DESCRIPTION
This command is entered in the Configuration Mode. PIM router sends periodic
join and prune messages on interfaces over which it has at least one
neighborship. Use this command to configure this interval (in seconds).
PARAMETERS
DEFAULT VALUE
The default message-interval is 60 seconds.
EXAMPLE
ALU(config)# ip pim message-interval 30
Parameter Description
0-4294967294 The DR priority range.
Parameter Description
1-65535 Denotes the interval between periodic join and prune
messages.