Point-to-Point Protocol over Ethernet (PPPoE)
Left running head:
Chapter name (automatic)
318
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
PPPOE NEGOTIATE
pppoe negotiate
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to initiate the PPPoE negotiation on the interface. This command helps to
terminate the existing PPPoE session, if any, and re-negotiate the session.
Note: PPPoE negotiation is automatically started when the link is administratively brought
up on a PPPoE interface. It starts off by sending a PADI.
Also, whenever “encapsulation pppoe” is configured on an administratively up GigE
interface.
PARAMETERS
None.
DEFAULT VALUE
None.
PLATFORMS SUPPORTED
OmniAccess 5740 USG
EXAMPLE
ALU(config-if GigabitEthernet3/0)# pppoe negotiate
RELEASE HISTORY
Release 2.3: command was introduced.
To Next Page
Loading...
Need help?
General
