Alcatel-Lucent OmniAccess 5740 - Tunnel Df-Bit; Tunnel Source

Generic Routing Encapsulation
Left running head:
Chapter name (automatic)
872
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
Alcatel-Lucent
TUNNEL DF-BIT
tunnel df-bit {clear|set|copy-from-inner-ip}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the value of the DF-bit for the Outer-IP header.
PARAMETERS
DEFAULT VALUE
The default DF-BIT value is ‘clear’.
EXAMPLE
ALU(config-if Tunnel7)# tunnel df-bit clear
TUNNEL SOURCE
tunnel source {<ip-address>|<interface-name>}
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command
sets the source IP address of the tunnel.
PARAMETERS
DEFAULT VALUE
None.
EXAMPLE
ALU(config-if Tunnel7)# tunnel source 10.91.0.7
or
ALU(config-if Tunnel7)# tunnel source GigabitEthernet3/0
Parameter Description
clear Clears the DF-bit.
set Sets the DF-bit value.
copy-from-inner-ip Copies from the original IP header.
Parameter Description
ip-address Source IP address of the tunnel.