Alcatel-Lucent OmniAccess 5740 - Tacacs-Server Timeout; Telnet Enable|Disable

tacacs-server timeout
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
149
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
TACACS-SERVER TIMEOUT
tacacs-server timeout <1-1000>
DESCRIPTION
This command is entered in the Configuration Mode. This command is used to
specify a global timeout value that will be applied to all the TACACS+ Groups
(provided there is no server specific timeout value configured).
PARAMETERS
DEFAULT VALUE
The default timeout value is 5 seconds.
EXAMPLE
ALU(config)# tacacs-server timeout 10
TELNET ENABLE|DISABLE
telnet {enable|disable}
DESCRIPTION
This command is entered in the Configuration Mode. Use this command to
enable/disable the Telnet service.
PARAMETERS
EXAMPLE
ALU# telnet enable
Parameter Description
timeout <1-1000> Number of seconds that the
OmniAccess 5740 USG should wait for a
reply from the TACACS+ server before
retrying.
Parameter Description
enable Enable telent service
disable Disable telnet service