mtu
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
177
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
MTU
mtu <64-1500>
DESCRIPTION
This command is entered in the Interface Configuration Mode. This command is
used to configure the MTU of the interface, i.e., the maximum size of the
transmitted layer 2 payload.
PARAMETERS
DEFAULT VALUE
The default MTU is 1500 bytes.
EXAMPLE
ALU(config-if GigabitEthernet3/0)# mtu 1000
NO DUPLEX
no duplex
This command is entered in the Interface Configuration Mode. This command
restores the default duplex operation. The default on a GE interface is auto.
NO ENCAPSULATION DOT1Q
no encapsulation dot1q
This command is entered in the Sub-interface Configuration Mode. This command
is used to remove the dot1q encapsulation on the GigE sub-interface.
NO FLOWCONTROL
no flowcontrol {receive|send} {off|on}
This command is entered in the Interface Configuration Mode. This command
resets the configured flowcontrol on a GigE interface to its default. By default, the
flowcontrol option is “off”.
NO MTU
no mtu
This command is entered in the Interface Configuration Mode. This command
restores the interface default Maximum Transmission Unit (MTU).The default
MTU is 1500.
Parameter Description
64-1500 Size of packet in bytes in the range 64 -
1500.