Alcatel-Lucent OmniAccess 5740 - Neighbor Route-Reflector-Client; Neighbor Send-Community

neighbor route-reflector-client
Except on the first page, right running head:
Heading1 or Heading1NewPage text (automatic)
523
Alcatel-Lucent
Beta Beta
OmniAccess 5740 Unified Services Gateway CLI Command Reference Guide
NEIGHBOR ROUTE-REFLECTOR-CLIENT
neighbor {<ip-address>|<peer-group-name>} route-reflector-
client
DESCRIPTION
This command is entered in the Address Family or Router Configuration Mode.
This command configures the neighbor as a BGP route reflector client.
PARAMETERS
DEFAULT
There is no route reflector in the AS.
EXAMPLE
ALU(config-router bgp AS30)#neighbor 35.0.0.1 route-reflector-
client
NEIGHBOR SEND-COMMUNITY
neighbor {<ip-address>|<peer-group-name>} send-community
DESCRIPTION
This command is entered in the Address Family or Router Configuration Mode.
This command specifies that community attribute should be sent to a BGP
neighbor.
PARAMETERS
DEFAULT
No community attribute is sent to any neighbor.
EXAMPLE
ALU(config-router bgp AS30)# neighbor 35.0.0.1 send-community
Parameter Description
ip-address IP address of the BGP neighbor being identified as a client.
peer-group-name Name of a BGP peer group.
Parameter Description
ip-address Neighbor’s IP address.
peer-group-name Name of a BGP peer group.